This model has been discontinued and only 32-bit boards are available, order here

https://warm.fit/products/tenlog-dmp-7-axis-32-bit-motherboard-marlin-2-0-with-wi-fi-for-tl-d3-d5-d6

Mechanical Sensor of Y axis under the Hot Bed	Photoelectric Sensor of Y axis under the Hot Bed

The screw holes of V1 and V2 are completely different and cannot be installed universally. Please purchase your original version of the screen.

Tenlog DMP 7-axis Motherboard (Version 2)
TMC2208 Driver
Each Small Motherboard Enjoy a Fan
Add 1 More Fan than the Version 1
The Version 1 and 2 Motherboard Use the Same Firmware
You Can Only Use the Same Motherboard as Your Current Host, the Wrong Version Will Lose the Warranty!

All Tenlog DMP Motherboard can use any Tenlog firmware.

Here is manual to upgrade firmware.

Tenlog DMP 7-axis Motherboard contains 7*TMC2208 drivers, Only Suitable for New Version Hands 2, TL-D3 Pro, TL-D5, TL-D6 Tenlog DMP 3D Printer.

You can choose a touch screen is equipped with a brand new UI.

Motherboard:

Input Voltage: 24V

Hot Bed Output Voltage: 24V

Support Power-loss Recover & Filament Runout Detection

SD Card Slot*1

USB Type-B Port*1

Tenlog 15Pin All-in-One Connector*2

Controllable Number of Motors: 7

Master Chip: Mega2560

Whether to Pre-install Firmware: Yes, with Newest Version

V1 Version Touch Screen:

4.3-inch 480*272 LCD Touch Screen for TL-D3 Pro, TL-D5, TL-D6    OR

3.5-inch 480*320 LCD Touch Screen for Hands 2

Whether to Pre-install Firmware: Yes, with Newest UI