naturally like your web-site however you need to take a look
at the spelling on quite a few of your posts.
Several of them are rife with spelling issues and I in finding it very troublesome to tell the truth on the other hand I will certainly come again again. https://ukrain-forum.biz.ua
excellent post, very informative. I wonder why the opposite
experts of thhis sector do not understand this. Youu must
proceed your writing. I am confident, you’ve a great
readers’ base already! https://Ukrain-Forum.Biz.ua/
Can you send me DWIN-SET Directory for TL-D3 Pro Stock Version
I have seen a few different set of instructions for installing firmware. 1 set said I needed to install the XLoader and drivers to install the firmware. Your instructions say to just download the firmware from the link above (which I did) then simply put the proper firmware for my system (the TL-D3 V2) into the user directory on a 16GB TF and insert it into the printer and power it on. Is it that simple?
Can you please send me a mainboard firmware file for the following? TENLOG 3D Printer Marlin 2.0 Silent Board Motherboard 32bit New Upgrade Controller Board with WiFi（no TF card）Support TMC2209 Drivers Compatible with TFT LCD Display FDM 3D Printers DIY Mainboard × 1
TL-32MB+drive+TJC screen
Thanks in advance.
Choosing a selection results in a full page refresh.
1066 comments
naturally like your web-site however you need to take a look
at the spelling on quite a few of your posts.
Several of them are rife with spelling issues and I in finding it very troublesome to tell the truth on the other hand I will certainly come again again. https://ukrain-forum.biz.ua
excellent post, very informative. I wonder why the opposite
experts of thhis sector do not understand this. Youu must
proceed your writing. I am confident, you’ve a great
readers’ base already! https://Ukrain-Forum.Biz.ua/
Can you send me DWIN-SET Directory for TL-D3 Pro Stock Version
I have seen a few different set of instructions for installing firmware. 1 set said I needed to install the XLoader and drivers to install the firmware. Your instructions say to just download the firmware from the link above (which I did) then simply put the proper firmware for my system (the TL-D3 V2) into the user directory on a 16GB TF and insert it into the printer and power it on. Is it that simple?
TL-32MB+drive+TJC screen
Thanks in advance.