Independent Dual Extruder 3D Printer Motherboard (Version 1) [Stop Production]
We have end A4988 Version, only TMC2208 Version is available.
Tenlog DMP 7-axis Motherboard with TMC2208 Driver, Work quieter and stable. This motherboard is pre-installed with 7pcs drivers, and with our newest Smart DMP 3D Printing Firmware.
The Version 1 and 2 Motherboard Use the Same Firmware
You Can Only Use the Same Motherboard as Your Current Host, the Wrong Version Will Lose the Warranty!
Tenlog DMP 7-axis motherboard contains seven TMC2208 drivers, Suitable for Hands 2, TL-D3 Pro, TL-D3S, TL-D5, TL-D6.
This kit comes with a touch screen and is equipped with a brand new UI.
Input Voltage: 24V
Hot Bed Output Voltage: 24V
Support Power-loss Recover & Filament Runout Detection
SD Card Slot*1
USB Type-B Port*1
Tenlog 15Pin All-in-One Connector*2
Controllable Number of Motors: 7
Master Chip: Mega2560
Whether to Pre-install Firmware: Yes, with Newest Version
|Input Voltage (recommended)||7-12V|
|Input Voltage (limit)||6-20V|
|Digital I/O Pins||54 (of which 15 provide PWM output)|
|Analog Input Pins||16|
|DC Current per I/O Pin||20 mA|
|DC Current for 3.3V Pin||50 mA|
|Flash Memory||256 KB of which 8 KB used by bootloader|
|Clock Speed||16 MHz|
4.3-inch 480*272 LCD Touch Screen for TL-D3 Pro, TL-D5, TL-D6 OR
3.5-inch 480*320 LCD Touch Screen for Hands 2
Whether to Pre-install Firmware: Yes, with Newest UI
How to Upgrade Drivers to TMC2208 from A4988
New method, no need to change pin of motor wire
watch video here
1. Please make sure that the drive module and motherboard are placed in the direction shown in the figure below. Please note the direction of the screws in the red circle⭕.
2. Change the wire sequence of the total 7 motors as shown in the figure below.