Independent Dual Extruder 3D Printer Motherboard (Version 1) [Stop Production]

We have end A4988 Version, only TMC2208 Version is available.
Tenlog DMP 7-axis Motherboard with TMC2208 Driver, Work quieter and stable. This motherboard is pre-installed with 7pcs drivers, and with our newest Smart DMP 3D Printing Firmware.
The Version 1 and 2 Motherboard Use the Same Firmware
You Can Only Use the Same Motherboard as Your Current Host, the Wrong Version Will Lose the Warranty!

Tenlog DMP 7-axis motherboard contains seven TMC2208 drivers, Suitable for Hands 2, TL-D3 Pro, TL-D3S, TL-D5, TL-D6.

This kit comes with a touch screen and is equipped with a brand new UI.

Motherboard:

Input Voltage: 24V

Hot Bed Output Voltage: 24V

Support Power-loss Recover & Filament Runout Detection

SD Card Slot*1

USB Type-B Port*1

Tenlog 15Pin All-in-One Connector*2

Controllable Number of Motors: 7

Master Chip: Mega2560

Whether to Pre-install Firmware: Yes, with Newest Version

Touch Screen:

4.3-inch 480*272 LCD Touch Screen for TL-D3 Pro, TL-D5, TL-D6    OR

3.5-inch 480*320 LCD Touch Screen for Hands 2

Whether to Pre-install Firmware: Yes, with Newest UI

​

How to Upgrade Drivers to TMC2208 from A4988

New method, no need to change pin of motor wire

watch video here

https://www.tenlog3d.com/blog/how-to-upgrade-a4988-to-tmc2208_b22

Old Method:

1. Please make sure that the drive module and motherboard are placed in the direction shown in the figure below. Please note the direction of the screws in the red circle⭕.

2. Change the wire sequence of the total 7 motors as shown in the figure below.